Solistone Commercial logo

 

spacer RECOMMENDATIONS & GUIDELINES FOR THE INSTALLATION OF LIMESTONE VENEERS
spacer


RECOMMENDED INSTALLATION

This document contains only guidelines for the installation process. A professional installer should always be consulted to discuss the specific parameters surrounding your project.

separator line

CURVED SURFACES
Solistone Commercial limestone veneers cannot be installed around curved surfaces unless the pieces are stacked vertically.

SUBSTRATES
All substrates should be firmly fixed, flat, clean, dry and free of contaminants such as dust, oil, paint, sealers etc. to ensure proper adhesion. Painted surfaces must be scuffed or sanded for the product and adhesive to bond correctly. Wet areas need special attention and require appropriate substrates, e.g. concrete, cement boards (compressed sheet), and/or treated plywood.

WATERPROOF MEMBRANES
Waterproof membranes prevent leakage of water through to the sub-floor framing and/or habitable spaces below. Particular attention must be paid to: carrying the membrane up the wall, outside shower boxes, installation of bond breakers, and sealing around penetrations. It is strongly recommended that membrane systems be used in all wet areas. Some systems may involve the use of a primer.

CUTTING
Cuts can be done with either a wet saw or a hand grinder using a diamond or masonry blade.

ADHESIVE
Follow the adhesive manufacturer’s instructions carefully. We do not recommend one brand of adhesive over another. Please check with your local tile supply store for alternative and comparable products.

 

 

 

The manufacturer's literature will explain if the adhesive product is suitable for interiors and/or exteriors, as well as walls and floors. Most thinset mortars (multi purpose and polymer modified thinsets) are adequate for installing slate tile. A cement-based adhesive is generally suitable on masonry substrates where no movement is anticipated. Where slight movement could occur through thermal or pedestrian loads, a modified cement adhesive should be used as a minimum. A 1/4” – 1/8” notch trowel is recommended for most applications. It is very important to make sure the tiles fit tightly together. The use of a rubber mallet may be required to gently tap the tiles into place.

GROUTING
Grouting is not necessary for the limestone veneers. If small cracks or seams exist in between each veneer, a sanded grout similar in color to the stone can be used to fill the gaps.


SEALANTS
To bring your application to its full potential, we suggest sealing. There are various products available on the market, however, we recommend contacting your nearest tile supplier for the most appropriate sealer for your application. You can change the look and color of the stones depending on the sealer you select ranging from color enhancement, to different levels of gloss finishes, or just leave them natural. Whenever using sealants and acids, please ensure that you follow the manufacturer’s recommended method of application.


CARE & CLEANING
Solistone Commercial limestone veneers must be regularly cleaned and maintained to extend the life and beauty of the tile. The stones can be cleaned with a neutral mild detergent. Consequently, any spills should be cleaned quickly to lessen the degree of the stain. The porosity or water absorption in these products varies and therefore staining will occur in different degrees if the stone is unsealed. Do not use abrasive cleaners, powders, scouring pads, steel wool or sandpaper.

 

Download Installation Recommendations (PDF)

       
gray line    SOLISTONE Commercial Copyright © 2016. All Rights Reserved. | Terms & Conditions